Reinstall The Drive; Figure 4-4: Removing An Arcvault Half-Height Drive - Overland Storage ARCvault Series Service Manual

3. Slide the old drive out of the guides leaving the other drive or air dam in place.
If necessary, loosen the screws on the other drive or air dam.
4. Slide the new drive into the guides.
5. Using the new M3x6mm screws, attach the drive to the guides.

4.1.4 Reinstall the Drive

1. With the wiring positioned off to the right, slide the drive and guides assembly back into
the drive bay.
2. Reattach the power and serial cables to the drives.
IMPORTANT: For dual half-height drives, you must attach the black serial cable to the top drive
and the white serial cable to the bottom drive.
3. Holding the drive cover below the drive opening, reattach the SCSI cable to one or both of
the drives.
4. Plug in the fan connector.
5. Reseat the drive cover and tighten the two thumbscrews.
Be sure all drive wiring is secure in the space behind the drive assembly and not caught
between the drive cover and the unit.
6. Reinstall the LVD SCSI cable and terminator to the drive cover.
7. Plug in the power cord and power on the unit.
8. Check the OCP Status to verify that the unit recognizes the new drive.
10400025-101 10/2006
Drive Front
Screws
(Located in Slots)

Figure 4-4: Removing an ARCvault Half-Height Drive

Adding or Replacing Components
Right Guide Left Guide
Air Dam
4– 3