Removing Drive Assembly; Incorporating The New Chassis; Install Drive Assembly; Reattach Drive Cover - Overland Storage ARCvault Series Service Manual

4. Remove the ARCvault unit from the rack and place it on a secure, flat surface.
NOTE:

4.4.1.3 Removing Drive Assembly

1. Loosen the two thumbscrews on the drive cover.
2. Remove the drive cover
a. Gently pull the drive cover out and hold it down about 2 inches (5cm) below the unit.
b. Unplug the fan wiring from the fan connector.
c. Unplug the SCSI cable from the drives.
d. Set the drive cover aside.
3. Unplug the drive power cables and position them off to the right.
4. Disconnect the serial jumper cable from the serial connector.
Leave the serial jumper cable attached to the drive assembly and move the other cables off to
the right.
5. Grasp the guide grips and slide the drive assembly out of the unit.

4.4.2 Incorporating the New Chassis

4.4.2.1 Install Drive Assembly

1. Swap out the chassis assemblies.
2. Loosen the two thumbscrews on the new drive cover and set it aside.
3. Slide the drive assembly into the new chassis.
4. Plug the power cables into the backs of the drives.
5. Attach the serial jumper cable from the drive assembly to the serial connector.

4.4.2.2 Reattach Drive Cover

1. Holding the drive cover below the drive bay opening, reconnect the SCSI cable and the fan
wiring.
2. Reseat the drive cover and tighten the thumbscrews.
10400025-101 10/2006

Figure 4-8: Retaining Screw Location

Early models require a tool (such as a screwdriver) to release the safety catches.
(Figure
Adding or Replacing Components
4-2).
Retaining Screw
4– 7