Section 2 - System Overview; Installation; Shipping Tie-Down Wire; Tie-Down Removal - Overland Storage ARCvault Series Service Manual

2
System Overview
SECTION

2.1 Installation

2.1.1 Shipping Tie-Down Wire

CAUTION: A tie-down wire holds the shuttle and robotics in place for shipment and MUST be removed before
operating the unit. Failure to remove this tie-down will result in damage to the internal robotics and
catastrophic failure of the unit.

2.1.1.1 Tie-Down Removal

1. Turn the library on its side
2. Untwist the tie-down wire underneath near the front center.
3. At the wire end closest to the center of the unit, push
the unit.
10400025-101 10/2006
WARNING: Due to the weight of the unit, it is recommended that at least two people be used to
lift the unit to prevent injury.
(Figure

Figure 2-1: Location of Robotics Tie-Down Wire Underneath Library

2-1).
Robotics Tie-Down
(Must Be Removed)
(Figure 2-2) part of the wire up into
2– 1