Figure 2-7: Attaching Outside Rails; Figure 2-8: Tighten Retaining Screws To Rack - Overland Storage ARCvault Series Service Manual

5. Attach two clip-nuts to the retaining screws holes on the front rack flanges.
6. Move the slides all the way forward to assist with the installation of the unit.
7. Lift the ARCvault unit and, aligning the inner rails into the outer rails on the rack, gently
slide it into the rack until the rail stops engage. Release the rail stops and continue sliding
the unit into the rack until the front panel touches the front flanges.
NOTE:
8. Tighten the two retaining screws behind the doors
9. Attach all network cables and power cords (see "Attaching Cables" on page 2-6).
10400025-101 10/2006
Front Flanges

Figure 2-7: Attaching Outside Rails

Early models require a tool (such as a screwdriver) to release the safety catches.

Figure 2-8: Tighten Retaining Screws to Rack

Rear Flanges
Bar Nut
Clip Nut
(Figure 2-8) to secure the unit.
Retaining Screw
System Overview
Adjustment Nuts
2– 5