Replace Full-Height Drive; Replace Half-Height Drive; Figure 4-2: Drive Cover Scsi And Fan Cables; Figure 4-3: Reattaching The Brackets To A Full-Height Drive - Overland Storage ARCvault Series Service Manual

Section 4
6. Unplug the power and serial cables from the drives and position them off to the right.
7. Grasp the guide grips and slide the drive assembly out of the unit.

4.1.2 Replace Full-Height Drive

NOTE:
1. Remove the four screws that secure the old drive to the drive assembly guides.
2. Position the guides on each side of the new drive
3. Using the new M3x6mm screws, attach the guides to the new drive.

4.1.3 Replace Half-Height Drive

1. For an ARCvault 24 library configured with dual half-height drives, determine the drive
to be replaced.
The top drive is always the lower-numbered drive.
2. Remove the four screws that secure the half-height drive being replaced to the guides
(Figure
4–2
Serial Cable
Right Guide
Drive Cover

Figure 4-2: Drive Cover SCSI and Fan Cables

To replace a half-height drive, go to "Replace Half-Height Drive" on page 4-2.

Figure 4-3: Reattaching the Brackets to a Full-Height Drive

4-4).
Power Cables
SCSI Cable
(Figure 4-3).
Left Guide
Fan Cable
Connector
10400025-101 10/2006