Replacing Drive Cover Assembly; Remove Old Assembly; Install New Assembly; Replacing A Media Magazine - Overland Storage ARCvault Series Service Manual

Section 4

4.2 Replacing Drive Cover Assembly

The drive cover assembly includes the exhaust fan
replace the entire assembly.

4.2.1 Remove Old Assembly

1. At the OCP, press Power > Power Off Library to power down the unit.
2. After the unit has shut down, remove the power cord.
3. At the rear, remove the LVD SCSI cable and terminator.
4. Loosen the two thumbscrews on the sides of the drive cover.
5. Remove the drive cover assembly.
a. Gently pull the assembly out and hold it approximately 2 inches (5cm) below the unit.
b. Unplug the fan wiring from the fan connector.
c. Unplug the SCSI cable from the drives.
d. Set aside the old assembly.

4.2.2 Install New Assembly

1. Holding the new drive cover assembly below the drive bay opening, connect the SCSI cable
to the back of the drives and plug in the fan wiring.
IMPORTANT: Be sure all drive wiring is secure in the space behind the drive assembly and not
caught between the drive cover and the unit when reseating the cover.
2. Seat the assembly in the drive bay opening and tighten the two thumbscrews.
3. Reinstall the LVD SCSI cable and terminator.
4. Plug in the power cord and power on the unit.
5. Check the fan to verify it is working.

4.3 Replacing A Media Magazine

Should it become necessary to replace a media magazine, a replacement magazine can be ordered
separately.
4–4
(Figure

Figure 4-5: Drive Cover Assembly

4-5). Should the fan or wiring fail,
10400025-101 10/2006