Step 3 - Sensor Configuration - FlowLine EchoPod UG06 Series Manual

Configuration Using WebCal
®
With EchoPod connected to your computer, open the WebCal
Follow steps 3-6 to configure the transmitter. Click "Help" in the lower right hand corner and open the help
®
menu of WebCal for instructions on WebCal
contact a Flowline applications engineer at (562) 598-3015. Note: For complete information on the WebCal
software, please refer to the WebCal

STEP 3 - SENSOR CONFIGURATION:

Configures the Loop Fail-Safe, Output at Empty and Startup Condition for the sensor.
Note: When connecting the sensor to the WebCal
not connect. Once completed, you can re-connect the display to the terminal.
MN310140 Rev A3
®
(continued)
®
. If you need additional assistance using WebCal
®
manual located at .flowline.com/webcal-software/.
Note: When configuring EchoPod
either the WebCal
Either method will accomplish the goal of
sensor configuration.
configuration can be made using the
alternative method. When beginning with
one
complete the configuration before using the
other method to make any adjustments.
®
Software, you must remove the display or the software will
®
* software by clicking on the WebCal
®
or Push Button method.
method, it is recommended
Step Three
®
icon.
®
, please
®
®
, choose
Changes to the
to
19 |