Usb Fob Interface - FlowLine EchoPod UG06 Series Manual

Configuration Using WebCal
®
USB FOB INTERFACE
®
EchoPod communicates with WebCal
(LI99-2001) into your computer's USB
www.flowline.com/webcal-software/
Connect the red, green, white and black wires from EchoPod
the screws on the terminals. Plug your Fob into the USB
Wiring to Fob (LI99-2001)
Wiring is identical for all EchoPod

The maximum cable distance between the computer and EchoPod
configuring the EchoPod
 ®
Once EchoPod is configured and prior to installation, isolate the white and green terminals from active
power to prevent a short from the configuration circuit.

Note: When using the Fob, do not add VDC or VAC power. The Fob, when connected to the computer, will
provide the required power to the EchoPod

Note: When connecting the sensor to the WebCal
will not connect. Once completed, you can re-connect the display to the terminal.

* For complete information on the WebCal
www.flowline.com/webcal-software/.
MN310140 Rev A3
®
(continued)
®
* through a USB
®
port, be sure that you have installed WebCal
) on your computer.
®
Series – Use only the Red, Black, Green and White wires.
®
.
®
.
®
software, please refer to the WebCal
®
interface called a Fob. Before plugging your Fob
®
into the correct terminals on the Fob. Tighten
®
port of your computer.
®
LI99-2001 USB Fob
®
is 15'. This only applies for
®
Software, you must remove the display or the software
Step Three
®
(see
Note: Only use the LI99-
®
2001 USB Fob (white).
®
The LI99-1001 USB Fob
(black) will not work with
®
the EchoPod series.
®
manual located at
17 |