Step 3 - Setting The Height - FlowLine EchoPod UG06 Series Manual

Configuration Using Display
STEP 3 - SETTING THE HEIGHT (SENSOR HEIGHT)
Note: The HEIGHT setting also determines the 4 mA current location. To reverse the current output with
20mA at the bottom of the tank, use the REV MA function.
Note: To speed up the scrolling of the values on the display, hold down the OK button while holding down the
UP or DOWN buttons.
MN310140 Rev A3
(continued)
1. In TOP-LEVEL MENU mode, select TANK.
2. Select HEIGHT.
3. Using the UP and DOWN buttons, set the HEIGHT of
4. To enter the value, press and hold OK for 5 seconds
5. Select EXIT to return to TOP-LEVEL MENU.
the tank (transducer face to the bottom of the tank).
and release. SAVED will display.
Step Four
25 |