Step 4 - Setting The Fill-H - FlowLine EchoPod UG06 Series Manual

Configuration Using Display
STEP 4 - SETTING THE FILL-H (FILL-HEIGHT)
Note: The Fill-Height (FILL-H) setting determines the 20 mA current span. To reverse the current output with
4mA being at the top of the tank, use the REV MA function.
Note: To speed up the scrolling of the values on the display, hold down the OK button while holding down the
UP or DOWN buttons.
| 26
(continued)
1. In TOP-LEVEL MENU mode, select TANK.
2. Select FILL-H.
3. Using the UP and DOWN buttons, set the Fill Height
4. To enter the value, press and hold OK for 5 seconds
5. Select EXIT to return to TOP-LEVEL MENU.
(FILL-H) of the tank (max. level of liquid to the bottom of
the tank).
and release. SAVED will display.
Step Four
MN310140 Rev A3