Configuration (With Webcal ® ) - FlowLine EchoPod UG06 Series Manual

Configuration Using WebCal
®
EchoPod can be configured before installation. The transmitter features non-volatile memory, so any setting
configured before installation will not be lost when the switch is powered down. To configure, follow the steps
below:
1. Install WebCal
a. Go to
b. Review how USB
2. Measure the Tank
a. Begin by measuring the key tank and fitting dimensions.
b. Correct tank dimensions will result in accurate sensor measurement.
3. Sensor Configuration
a. Configures Loop Fail-Safe, Output at Empty & Startup Condition for the sensor.
4. Dimensional Entry
a. Distance Mode (default)
i. Basic information for operation (Sensor Height & Fill-Height).
5. Tank Level Confirmation
a. Confirm the values are accurate for the application.
6. Write to Unit
a. Uploads configuration into the sensor.
b. Access to a customer wiring diagram specific to the relay configuration.
When configuring EchoPod
Note:
method will accomplish the goal of sensor configuration. Changes to the configuration can be
made using the alternative method. When beginning with one method, it is recommended to
complete the configuration before using the other method to make any adjustments.
MN310140 Rev A3
®
®
software
www.flowline.com/webCal-software/
®
Fob interfaces with EchoPod
®
, choose either the WebCal
and select language version.
®
and your computer.
®
or Push Button method. Either
Step Three
15 |