Step 2 - Setting The Units Of Measurement - FlowLine EchoPod UG06 Series Manual

Configuration Using Display
TOP-LEVEL MENU

The TOP-LEVEL MENU will continue to scroll
through the items listed to the right until the OK
button is pressed.

To return to the Normal / Operational mode of
®
EchoPod , press OK while RUN appears in the
display.
How to enter the TOP-LEVEL MENU
1. Press and hold OK (approximately 5 seconds) until
MENU is displayed.
2. The TOP-LEVEL MENU items will rotate through
display.
3. Use OK to choose a MENU item.
How to exit the TOP-LEVEL MENU
In TOP-LEVEL MENU, press OK when RUN appears.
STEP 2 - SETTING THE UNITS OF MEASUREMENT (UNITS)
1. In the TOP-LEVEL MENU mode, select UNITS.
2. Press OK to choose between INCHES, CM
(centimeter), FEET or METERS.
a. Press and hold OK on the selected setting for 2
seconds then release.
a. To cancel UNITS, Select EXIT.
3. Select EXIT to return to the TOP-LEVEL MENU.
®
Note: EchoPod will adjust the display when measurement
units are changed under UNITS. Example: If you are in
inches and the display reads 60.0, the display will change to
5.00 when feet is selected as the unit of measurement.
| 24
(continued)
Step Four
MN310140 Rev A3