Configuration Using WebCal
STEP 5 – TANK LEVEL CONFIRMATION:
Verify the Height Units, Sensor Height & Fill-Height. All values were calculated in the previous Dimensional
Entry window. To adjust these settings, click on Volumetric Modes.
STEP 6 – WRITE TO UNIT:
®
This WebCal
* operation uploads configuration into the sensor. Other features in the section include providing
a custom wiring diagram specific to the signal output and saving the configuration file to your hard drive.
Volumetric Sensor Output
The Volumetric Mode
button will be highlighted
in Blue when a volume
output is selected.
* For complete information on the WebCal
flowline.com/webcal-software/.
MN310140 Rev A3
®
(continued)
®
software, please refer to the WebCal
Step Three
®
manual located at
21
|