Installation; Mounting Guide - FlowLine EchoPod UG06 Series Manual

Inst tallation
®
Echo oPod shou ld always b
gask ket for G thr readed versi
worn n. Always h
hand-tighten
proc cess conditio ons prior to s
MOU UNTING GUID DE
1. D Do not moun nt at an angl
2. L Liquid should d never ente
3. S Side Wall:
a. Moun nt at least 3"
4. D Do not mou nt where ob
b beam width
a. moun nt at least 3"
5. D Do not moun nt in a vacuu
6. D Do not moun nt in the cent
7. I n cone bo ottom tank,
deepest part d t of the tank.
Insta allation in existing fit
large er than the threads of
bush hing such as s the LM52-
LM5 2-3800 (4" t hread x 2" th
LM52-2 2800
| 28
e mounted perpendicul
ions only). Make sure
n the transm mitter within
system start up.
e
er the dead b band
from the sid de wall
bstacles will l intrude on
from the sid de wall
um
ter of a dom me top tank.
position th he sensor
.
ttings: If t the existing
®
the EchoPo od , select a
-2800 (3" th hread x 2" t
hread).
LM52-3800 L
ar to the liq quid surface
that the fittin ng and trans
the fitting. Perform a
Do not
angle re
sensor's
Do not
3" of ta
over the
fitting is
a reducer
Do no
hread) or
obje
Do no
applic
va
Do not
center
to
(use the pr rovided Vito
smitter threa ads are not
an installed leak test u
t install at an n
relative to the e
liquid. l
install within n
ank sidewall. .
t install with
ects in the
beam. b
ot install in
cations with
acuum.
install in the e
r of a dome
op tank.
Step Five e
®
n mounting g
damaged o or
nder norma al
MN310140 Rev A A3