Analog Output - FlowLine EchoPod UG06 Series Manual

Wiring
(continued)

ANALOG OUTPUT

The analog output of the EchoPod
feature is to connect a positive supply to the Power (+) input terminal and to sense the current flow out of the
Power (-) output terminal with a sampling resistor as shown in the following diagram.
The cabling should be a shielded twisted pair to minimize EMI interference. Typically 20 to 24 gauge wire is
used in this application. To access the terminals, gently remove the display from the housing.
When wiring is completed, restore the display to the housing and replace the cover.
The UG06 series can operate without the display. When wired and powered correctly, the sensor will
continue to provide a proportional 4-20 mA signal.
| 34
®
is a loop powered 4-20 mA control circuit. The typical way to use this
Step Six
MN310140 Rev A3