STEP 4 - SENSOR CONFIGURATION
Configures the Loop Fail-Safe, Output at Empty and Startup Condition for the sensor.
STEP 5 – DIMENSIONAL ENTRY
Distance Mode (default): Output of sensor is based on the distance (height of liquid) in the tank. Any change
in liquid level will reflect linearly to the current output. The two values (Sensor Height and Fill-Height) below set
the 4-20 mA current span for the sensor. Both values will be set in the units shown under Height Units.
Height Units: Confirm units for use in Sensor Height and Fill-Height settings.
Sensor Height: Sets the location for 4mA. It is based on the distance from the Empty level position to
the Measurement location for the sensor (see below).
Fill-Height: Sets the location for 20mA. It is based on the distance from the Empty level position to
the Full level position (see below).
|
4
QS310140 Rev A1