Debugging - Digi XB3-C-A2-UT series User Manual

Getting started with the XBee Smart Modem Development Kit
9. Click the Consoles working mode button
device. For instructions on using the Console, see the
10. Click the Open button
11. Click in the left pane of the Console log, type hello world and press Enter. The XBee Smart
Modem sends the message to the destination phone number set by the P# command.
12. When the phone receives the text, you can see that the sender's phone number matches the
value reported by the XBee Smart Modem with the PH command.
13. On the phone, reply with the text connect with confidence and the XBee Smart Modem
outputs this reply from the UART.

Debugging

If you experience problems with the settings in this example, you can load the default settings in
XCTU:
1. On the Configuration toolbar, click the Default button
established by the firmware, and click Yes to confirm.
2. Factory settings are loaded but not written to the device. To write them, click the Write button
on the toolbar.
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
on the toolbar to open a serial console to the
to open a serial connection to the device.
Send an SMS message to a phone
AT console topic in the XCTU User Guide.
to load the default values
19