Hs (Hardware Series); Ck (Configuration Crc); Execution Commands; R (Modem Reset) - Digi XB3-C-A2-UT series User Manual

AT commands
Parameter
0x27
0x28
0xFF
Parameter range
0 - 0xFF (read-only)
Default
-

HS (Hardware Series)

Read the device's hardware series number.
Parameter range
N/A
Default
Set in the firmware

CK (Configuration CRC)

Displays the cyclic redundancy check (CRC) of the current AT command configuration settings.
Parameter range
0 - 0xFFFFFFFF
Default
N/A

Execution commands

The location where most AT commands set or query register values, execution commands execute an
action on the device. Execution commands are executed immediately and do not require changes to
be applied.

!R (Modem Reset)

Forces the cellular component to reboot.
CAUTION! This command is for advanced users, and you should only use it if the cellular
component becomes completely stuck while in Bypass mode. Normal users should never
need to run this command. See the
Range
N/A
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
Description
Connection lost.
Unknown.
No known status.
FR (Force Reset) command instead.

Execution commands

122