Rf Exposure; Ic (Industry Canada); Labeling Requirements - Digi XB3-C-A2-UT series User Manual

Regulatory information
6.74 dBi in 1700 MHz, i.e. LTE FDD-4 band
n
7.12 dBi in 1900 MHz, i.e. LTE FDD-2 band
n

RF exposure

If you are an integrating the XBee3 RF Module into another product, you must include the following
Caution statement in OEM product manuals to alert users of FCC RF exposure compliance:
CAUTION! To satisfy FCC RF exposure requirements for mobile transmitting devices, a
separation distance of 20 cm or more should be maintained between the antenna of this
device and persons during device operation. To ensure compliance, operations at closer
than this distance are not recommended. The antenna used for this transmitter must
not be co-located in conjunction with any other antenna or transmitter.

IC (Industry Canada)

Labeling requirements

Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on
the outside of the final product enclosure must display the following text.
Contains IC: 1846A-XB3M1
Contains IC: 8595A-2AGQN4NNN
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
RF Exposure
CAUTION! This equipment is approved for mobile and base station transmitting devices
only. Antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
ATTENTION! Cet équipement est approuvé pour la mobile et la station base dispositifs
d'émission seulement. Antenne(s) utilisé pour cet émetteur doit être installé pour fournir
une distance de séparation d'au moins 20 cm à partir de toutes les personnes et ne doit
pas être situé ou fonctionner en conjonction avec tout autre antenne ou émetteur.
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
IC (Industry Canada)
150