Volvo Edc4; Volvo-Ems2 - Smartgen HGM8140 User Manual

13.17 VOLVO EDC4

Suitable engine types: TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721, TAD722, and
TAD732.
Terminals of controller
Relay Output 1
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: VolvoEDC4

13.18 VOLVO-EMS2

Volvo Engine types are TAD734, TAD940, TAD941, TAD1640, TAD1641, and TAD1642.
Terminals of controller
Relay output 1
Relay output 2
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo-EMS2
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Table 40 - Connector
Connector
Expanded 30A relay, and
relay offers battery
voltage for terminal14.
Fuse is 16A
-
1
-
12
13
Table 41 - Engine CAN Connector
Engine's CAN port
6
5
3
4
-
1(Hi)
2(Lo)
Version 1.0
Remark
Configure relay output 1 as ―Fuel Output‖.
Connect to starter coil directly.
Connected to negative of battery.
CAN communication shielding line(connect with
controller's terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
ECU stop
Configurable output 1 ―ECU stop‖.
ECU power
Configurable output 2 ―ECU power‖.
Negative power
Positive power
CAN communication shielding line.
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
2016-12-07 Page 49 of 54