Table of Contents
Advertisement
CAN(L)
Engine type: Common J1939
13.14 PERKINS
It is suitable for ADEM3/ ADEM4 engine control module. Engine type is 2306, 2506, 1106, and 2806.
Terminals of controller
Relay Output 1
Start relay output
CAN_SCR
CAN(H)
CAN(L)
Engine type: Perkins
13.15 SCANIA
It is suitable for S6 engine control module. Engine type is DC9, DC12, and DC16.
Terminals of controller
Relay Output 1
Start relay output
CAN_SCR
CAN(H)
CAN(L)
Engine type: Scania
13.16 VOLVO EDC3
Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Terminals of controller ―Stand alone‖ connector
Relay Output 1
Start relay output
Auxiliary output 1
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine type: Volvo
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
X23 1
Table 36 - Connector
Connector
1,10,15,33,34
-
-
31
32
Table 37 - B1 Connector
B1 connector
3
-
-
9
10
Table 38 - ―Stand alone‖ Connector
H
E
P
Table 39 - ―Data bus‖ Connector
―Data bus‖ connector
-
1
2
Using impedance 120Ω connecting line.
Configure relay output 1 as ―Fuel Output‖.
Connect to starter coil directly.
CAN communication shielding line
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Configure relay output 1 as ―Fuel Output‖.
Connect to starter coil directly.
CAN communication shielding line.
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Configure relay output 1 as ―Fuel Output‖.
ECU power
Configurable output 1,"ECU power".
CAN communication shielding line.
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Version 1.0
2016-12-07
Remark
Remark
Remark
Remark
Page 48 of 54
Advertisement
Table of Contents
