Table of Contents
Advertisement
control, if it is able to control, HGM8140M can be controlled by HGM8140D, otherwise,
HGM8140D without remote control function.
Suitable for 3-phase 4-wire, 3-phase 3-wire, single phase 2-wire, and 2-phase 3-wire
systems with voltage 120/240V and frequency 50Hz/60Hz;
Collects and shows 3-phase voltage, current, power parameter and frequency of generator or
mains.
Mains
Line voltage (Uab, Ubc, and Uca)
Phase voltage (Ua, Ub, and Uc)
Frequency Hz
Phase sequence
Load
Current
IA，IB，IC
Each phase and total active power kW
Reactive power kVar
Power factor PF
Load output percentage %
Apparent power kVA
Accumulate total generator power kWh
For generator, controller has over and under voltage, over and under frequency, over current
and over power detection functions.
Precision measure and display parameters about Engine.
Temp. (WT)
Oil Pressure (OP)
Fuel Level (FL)
Speed (RPM)
Voltage of Battery
Voltage of Charger
Hour count accumulation
Start times accumulation
Protection: automatic start/stop of the gen-set, ATS (Auto Transfer Switch) control with
perfect fault indication and protection function.
With ETS (energize to stop), idle control, pre-heat control and rise/drop speed control
functions, which are all relay outputs.
Parameter setting: parameters can be modified and stored in internal FLASH memory and
cannot be lost even in case of power outage; most of them can be adjusted using front panel
of the controller and also can be modified using PC via USB or RS485 port.
Multiple temperature, pressure, oil pressure sensor can be used and self-defined directly.
Multiple crank disconnect conditions (speed sensor, oil pressure, generator frequency) are
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
° C/° F both be displayed
kPa/psi/bar all be displayed
%(unit)
Fuel Quantity Left L(unit)
r/min (RPM)
V (unit)
V (unit)
Version 1.0
2016-12-07
Page 5 of 54
Advertisement
Table of Contents
