Operation; Key Function - Smartgen HGM8140 User Manual

4 OPERATION

4.1 KEY FUNCTION

Icons Keys
Stop/Reset
Start
Manual Mode
Auto Mode
Close/Open
Menu/Confirm
Up/Increase
Down/Decrease
CAUTION: Default password is "0318", it is can be changed by the operator in case of other person
adjust the advanced configuration of controller freely. Please keep the password in your mind after
change it. If forget, please to contact with SmartGens's service personnel, and send all the information in
the page of "Controller Information".
Note: press any key can mute alarms.
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Table 3 – Buttons Description
Stop running generator in Auto/Manual mode; Reset alarms when genset
in alarming status; Lamp test (press at least 3 seconds) in stop mode;
During stopping process, press this button again to stop generator
immediately; Return back to homepage after press this key in main
screen and exist parameter settings after pressed this key in parameter
setting interface.
Start genset in Manual mode; jump to the next status in start-up process.
Press this key and controller enters in Manual mode.
Press this key and controller enters in Auto mode.
Close/Open breaker in manual mode.
Reset ―Trip‖ alarms for pressing over 3s.
Enter into menu interface; moving cursor to conform setting information
in parameter setting interface.
1) Screen scroll;
2) Up cursor and increase value in setting menu.
1) Screen scroll;
2) Down cursor and decrease value in setting menu.
Version 1.0
Description
2016-12-07 Page 8 of 54