Configuring The Unit - Vocality V200 User Manual

4

Configuring the Unit

The following is an overview of the first few configuration steps for your unit.
Step 1 Provide power and connect a computer to control your Vocality unit
Step 2 When prompted enter your username and password
Factory defaults are Username:Vocality and Password:Vocal1ty
(Note: The password uses the number 1 instead of the letter i.)
You can change these in the Users menu, once you have logged in.
Step 3 From the Banner page, select menus to configure
Figure 4-2 Web interface
Select from menu groups along the top
and menus down the left hand side.
When you change any data on
a menu the top of that menu will turn
orange.
After entering data select
Validate. If your change means extra fields
need to be completed, these will then
Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
Figure 4-1 Connecting your unit
Figure 4-3 M&C interface
Press the up arrow key < > to see the
menus.
To select a menu highlight it and press
Page 20 of 114