Ssh Password Mode; Ssh Key Mode; Feature Keys - Vocality V200 User Manual

Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
SSH expects a username and a password.
Note: You will only be permitted SSH access if IP > Access Table entries have been
configured to allow SSH client access.

4.3.2.1 SSH password mode

The account name and password supplied across SSH are validated: the unit will
support the full set of configured passwords.
Once this validation has happened, the unit presents any configured welcome message
and then re-prompts for the password.
Logout from the Vocality unit will leave the SSH session active – so you can login again
with the same or different password from that used to open the SSH session.
Note: For some users, such as the US DoD, it is important that a customised
welcome message is presented before the login attempt happens. This method
ensures that this happens, at the slight cost of entering the account/password
If no accounts are configured (or accounts are not enabled) then SSH will accept the
unit's node name as the login name and any password will be accepted.

4.3.2.2 SSH key mode

When the SSH server is configured for key authentication, the public key should be
configured in the ‡SSH > Key & Authentication menu. This public key must be the
public key component from the private key on the SSH client.
The login name used for SSH authentication is always the unit's node name.
If accounts are enabled, then after SSH key negotiation has completed you will be
presented with a login prompt. At this point you will need to use configured account
details to access the menus.
If accounts are not enabled, then after SSH key negotiation has completed you will be
able to access the menus straightaway.
4.4

Feature Keys

The following software features are only activated by the purchase of specific Feature
Keys:
SWF/IP MULTICAST - IP multicast routing (IGMP & PIM-DM) support

SWF/VOICE8 - Analogue Voice SWF > 8 Voice ports

SWF/VOIP/SIP10 - Block of 10 User Agents for SIP based VoIP functionality

SWF/VOIP/SIP REG - Activation of SIP Registrar functionality by specifying the

maximum number of clients
Page 32 of 114
SSH requires the Security software (RTUSEC)
and a Feature Key on all products.
twice.