Vocality V200 User Manual page 67

This will take you to the debug command prompt 'Dbg>'.
Type help then press <Enter> for a list of all valid debug commands. Commands are
not case-sensitive. All commands are converted to upper case.
Debug commands available include:
Debug Command Use
ACTIVATECFG Reload the active configuration from storage
AGG CALL STATS Show call stats for switched aggregates
AGG STATUS Show current aggregate port status
BOOT Reboot the system
BUFFER POOL STATS Report stats for all buffer pools
CAL Show clock calibration
DCHAN STATS RESET Reset packet/byte stats for data ports
DCHAN STATS Report packet/byte stats for data ports
DCHAN USAGE RESET Reset usage stats for data channels
DCHAN USAGE Report usage stats for data channels
DIAGSLOT Remote connect to slot
DHCP SERV STATUS Report DHCP server status
IPRM IP Route Management shell
Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
Figure 5-23 Entering debug mode
Page 57 of 114