Technique - Vocality V200 User Manual

Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
5.1.3

Technique

You will need to start at the Banner page on M&C interface and enter the commands
below. (Replace nodename by the node name of the unit, not the node ID.)
1. Enter TTY mode by typing <Ctrl> <E> then <Ctrl> tt.
2. To list all the settings type a command with the form 'nodename ?', for instance
remote1 ? <Return> (If you do not know the nodename just use the word
nodename.)
3. To capture the settings type a command with the form 'nodename ?' Do not
press <Return> yet. Start a capture file (see below) and then press <Return>,
this will copy your entire configuration to file.
4. Stop the capture.
To start a capture file in HyperTerminal:
Select from the top menu bar Transfer > Capture Text.

Select a place to store the file and a name for it. Press Start.

To stop a capture in HyperTerminal:
Select from the top menu bar Transfer > Capture Text > Stop

To start a capture file in PuTTYtel:
Alter your set up by choosing the Logging tab and check Session Logging:

'Printable Output'
Specify a name and location to save the resulting text file.

Return to the Session tab and press Save. Then start your session as usual.

To stop a capture in PuTTYtel:
Close your session

Reverse your setup changes by checking Session Logging: 'None'

Page 38 of 114
Figure 5-2 ASCII setup