Configuring Broadcast Services; Pre-Requisites - Vocality V200 User Manual

Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
Figure 5-71 IP > DHCP Server menu - relay mode
Note that this configuration is required on both Node 1 and Node 2.
Note: The DHCP relay only operates on ENET1.
5.20

Configuring broadcast services

Vocality units can be used in point-to-multipoint networks, where a number of remotes
may wish to receive the same data. In the example below, the hub unit is connected to a
number of four wire voice feeds and each remote has chosen to listen to a selection
from these. Figure 5-72 shows a simple network. An audio matrix is shown, but is not
required in most applications.
Figure 5-72 Simple broadcast audio network
This section explains how you can configure broadcast audio.

5.20.1 Pre-requisites

You are assumed to have configured aggregates (serial or IP) to each unit, which are
needed to receive the broadcast audio.
Page 100 of 114