Vocality V200 User Manual page 79

Step 2
Then, go to the ‡IP > IPSec > Keys menu (see Figure 5-26 ) and select <ADD KEY>.
Assign a name to the description field and then enter a pre-shared key.
Step 3
Next, go to ‡IP > IPSec > Tunnel Security Associations menu and select <ADD SA>.
Assign a name to the description field and change MODE to IKE.
Enter the IPSec tunnel peer address in the PEER ADDRESS field.
Select the SOURCE INTERFACE that has the IP address configured which is used to
identify this unit.
For the IKE PRE-SHARED KEY fields select the named key created in Step 2 .
Figure 5-31 IPSec > Tunnel Security Associations menu - IKE
Refer to the Menus appendix for details of all the parameters that can be set.
Step 4
Next you will need to go to IP > Service Management > Address Definitions menu
and select <NEW ENTRY> (see Figure 5-28 ).
Assign names to local addresses.
Enter an address and mask to identify local addresses.
Step 5
On the same page select <NEW ENTRY>.
Assign names for target addresses.
Enter an address and mask to identify target addresses for tunnelling.
Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
Page 69 of 114