Single Unit; Several Units - Vocality V200 User Manual

Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
On the above Banner Page the maintenance expiry date is 1st January 2015 and the
expiry version is Version 8. This allows the unit to be upgraded with any version 8 (or
before) software created before 1st January 2015. To update the license information you
would need to contact your Vocality support representative with the serial number of
your Vocality unit. They can issue the updated license information.
To obtain a valid licence key you will need the serial number of the unit being upgraded
(which can be read from the Banner page) and then you should contact your local
Vocality support representative.
Instructions are given below for updating the maintenance licence key in several
different situations:
updating a single unit;

updating several units;

special case: upgrading from pre-version 6 software;

special case: upgrading to software for which you do not have a licence.


5.4.2.1 Single unit

To program the new licence details, proceed as follows:
Either visit the Diagnostics >Diagnostics > Slot n > Update License menu or
From the Banner page type (uppercase):
D D D
M
Enter the instruction:
MAINT UPDATE dd-mmm-yyyy vers key, <Enter>
where dd-mmm-yyyy is the new expiry date, vers is the maximum major version number
allowed and key is the serial number specific licence key for the unit being
programmed.
For example: MAINT UPDATE 01-Apr-2016 9 52jpKW3, <Enter>
Once entered the following message will be displayed:
Software maintenance expiry info updated, Restarting supervisor
to activate
The supervisor session will restart (the unit will not reboot) and the entered information
will be displayed on the Banner page. Please ensure it is correct.

5.4.2.2 Several units

Alternatively, several units can have their licences updated in an identical fashion via a
licence file available from your local Vocality support representative. This file is TFTP
uploaded to the units to be programmed.
To use this file, enter diagnostics mode (from the Banner page press: <Shift> ddd M)
and use the LICENSE UPDATE command.
Page 44 of 114