Vocality V200 User Manual page 4

Any SELV 10/100base-T network plugs used - which could accidentally be plugged into the
telephone ports - must have their key tabs removed such that they can only be removed
using a special tool. This equipment must therefore only be professionally installed by
This equipment allows connection only of suitably approved equipment to its ports, the
Supervisor/Alarm port, DB15HD Data ports, VHDCI Data ports, 10/100/1000base-T Ethernet
Ports, Alarm port, Four Wire E&M Radio Relay ports and Digital Voice ports
The above named ports are classified as SELV (Safety Extra Low Voltage) in accordance with
EN60950-1:2006, and must only be connected to equipment which similarly complies with
FXO module voice ports (connect only to PBX extension ports which provide isolation from
FXS module voice ports (connect only to telephones )
The above named ports, classified as TNV2 (Telecom Network Voltage Type 2) in accordance
EN60950-1:2006, must only be connected to circuits complying with the requirements
The unit complies with EMC emissions standards BS EN 61000-6-3:2001 and immunity
BS EN 61000-6-1:2001 and BS EN 61000-6-2:2005 . In order to meet the requirements of
these standards, the card must be operated with screened link, channel and supervisor
cables. Failure to do so may result in non-compliance.
iv
WARNING: INSTALLATION OF EQUIPMENT
suitably trained service personnel.
safety status of which is defined below.
SELV Ports:
the SELV safety classification.
TNV2 Ports:
TNV3 voltages)
with
therein.
standards