Software Configuration - Vocality V200 User Manual

5.13.2 Software configuration

The steps which follow, describe the configuration sequence for an IP aggregate.
First, you will need to configure the IP port with a valid IP address on the IP >
Networks menu
Next you need to create a new IP aggregate on the IP > IP Aggregates menu.
A typical point-to-point IP aggregate, with no other clocks in the system, will have
TX CLOCK for the IP aggregate at the master end of the link set to 'GC1' (master or
internal clock), as shown below, and on the other end '–'.
Note: Use <Spacebar> to toggle through alternative parameter settings.
In this example an IP aggregate is configured between Node 2 and Node1.
Note: If there is more than one IP aggregate present on a node, then each one
Node 2 is configured, as shown in Figure 5-39 , as the slave end of the link, that means
TX CLOCK is set to '–'.
Figure 5-38 IP Aggregates menu - Node 1
must use a different UDP port.
Figure 5-39 IP Aggregates menu - Node 2
Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
Page 75 of 114