Water Tank Mc / Mc X - Dentsply Sirona CEREC MC Operating Instructions Manual

Dentsply Sirona
Operating Instructions CEREC MC / MC X
63 98 643 D3439
D3439.201.07.11.02 01.2018
7.3.2.1

Water tank MC / MC X

B
A
Water tank
A Filter insert
B Tank cap
To change the water, proceed as follows:
ü The unit is switched on.
ü No machining process is running.
1. Pull out the water tank at the front of the unit.
2. Open the drain opening.
3. Drain the water tank.
4. Turn the tank cap counter-clockwise and take it off. If you find the
tank cap hard to open by hand, use the tank cap opener (see
"Opening the tank cap").
5. Remove the filter insert from the tank and clean the filter thoroughly
under running water.
6. Rinse the water tank.
7. Insert the cleaned filter with handle into the tank and press it firmly
onto the base in the floor of the tank.
8. Close the drain opening.
NOTE
Foaming not permissible!
If any cleaning agents are used, this will create foam, which is not
permitted.
Do not use any cleaning agents.
7.3 Changing the water
C Tank
D Tank drain
7 Service
C
D
51