Dentsply Sirona - Dentsply Sirona CEREC MC Operating Instructions Manual

Dentsply Sirona

Operating Instructions CEREC MC / MC X
63 98 643 D3439
D3439.201.07.11.02 01.2018
5.4.7.7.2 CEREC Radio Device
Creating a network
The supplied network devices have not as yet been part of a network.
To enable several networks from various operators to be created next to
one another or in the same area, new network devices must first form a
network. This is described in the following section.
To create a new network with several new network devices, perform the
following steps:
1. Place all network devices in the same area.
2. Switch all network devices on within one minute.
3. After switching on the last network device, wait approx. one minute.
4. Make sure that all network devices are connected, as indicated by
the green LED; see section "LED displays" in the "CEREC Radio
Device" operating instructions (REF 65 45 177).
All network devices now belong to a single network, which can be
operated as an independent network, and can communicate with one
another. In the event of problems, see section "'Network creation
failures" in the "CEREC Radio Device" operating instructions (REF 65
45 177).
Extending the network - adding a new network device
New network devices can be added to an existing network. To prevent
random network devices from becoming part of the network, the user
must perform the following steps:
1. Place the new network devices next to a network device that is part
of the network.
2. Switch on the new network devices.
3. Switch the existing network device off and on again within one
minute.
Ä After one minute the new network devices will become part of
the network.
IMPORTANT
A network with CEREC Radio Devices can include up to three
network devices. Larger networks are not possible.
5 Installation and startup
5.4 Commissioning
29