Installing The Unit - Dentsply Sirona CEREC MC Operating Instructions Manual

5 Installation and startup
5.4 Commissioning
22
5.4.7.3

Installing the unit

You must connect the unit to the PC before putting it into operation.
This is described in the section entitled "Connecting to the PC via LAN"
[→ 21] or "Connecting to the PC via WLAN (option)" [→ 26].
Searching for unit automatically
The unit is connected to the PC via a LAN cable or via WLAN.
1. Click the "Configuration" button in the system menu.
2. Click on the "Devices" button.
3. Click on the "Scan for New Devices" button.
Ä All units connected to the PC are recognized. In the case of
new units, you will be prompted to enter a name.
4. Enter a name for the new unit.
Search for unit manually
The unit is connected to the PC via a LAN cable or via WLAN.
1. Click the "Configuration" button in the system menu.
2. Click on the "Devices" button.
3. Click on the "Add Device (Manual)" button.
4. Set the network.
5. Enter the network address which appears on the "IP address:"
display once the milling and grinding unit has been switched on.
6. Click on the "Ok" button.
Ä The software attempts to contact the device.
If the connection fails, check the connection. If necessary, ask a
qualified technician.
Unit removal
ü If you no longer require a unit (e.g. a unit is replaced), you can
remove it.
ü The unit is operation.
1. Click the "Configuration" button in the system menu.
2. Click on the "Devices" button.
3. Click on the unit that you wish to uninstall.
4. Click on the "Delete Device" button.
Ä You will be asked if you would like to remove the unit.
5. Click on the "YES" button.
Ä The device is removed.
Dentsply Sirona
Operating Instructions CEREC MC / MC X
63 98 643 D3439
D3439.201.07.11.02 01.2018