Inserting The Processing Chamber Screen And Upper Screen; Connecting The Bar Code Reader - Dentsply Sirona CEREC MC Operating Instructions Manual

5 Installation and startup
5.4 Commissioning
20
5.4.5 Inserting the processing chamber screen and upper
screen
NOTE
Risk of blockage in the cooling circuit
If chips enter into the cooling circuit of the machine, there is a risk that
the cooling circuit will become blocked.
➢ The processing chamber screen is suitable for all restoration and
material types. It is absolutely essential that no chips enter into
the cooling circuit.
Inserting the upper screen
The upper screen enables simpler cleaning of processing chambers
when milling CEREC Guide 2 drilling templates. It can also be used with
other materials, but is particularly helpful when it comes to removing
material waste, which gathers during each milling process of CEREC
Guide 2 on the floor of the processing chamber.
1. Position the upper screen on the existing processing chamber
screen on the floor of the chamber. If needed, you can easily
remove and clean the upper screen. It is essential that the upper
screen is emptied and washed following each milled drilling
template.
2. Check the water level in the water tank following each milled drilling
template, as water is absorbed in the material waste.
5.4.6

Connecting the bar code reader

The bar code reader is optional for the CEREC MC/MC X unit.
Connecting the bar code reader
➢ Plug the bar code reader into the serial interface to the rear of the
milling and grinding unit and secure with screws.
Dentsply Sirona
Operating Instructions CEREC MC / MC X
63 98 643 D3439
D3439.201.07.11.02 01.2018