Installing A Rear I/O Module - Cobalt Digital Inc 9903-UDX-ADDA Product Manual

3g/hd/sd-sdi universal udx format converter/ frame sync with cvbs/ypbpr video i/o, aes and analog audio embedding / de-embedding
Table of Contents

Advertisement

Installation and Setup

Installing a Rear I/O Module

9903UDXADDA-OM (V1.5)
Note:
If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be
discovered by DashBoard™ and be ready for use.
Note:
This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9903-UDX-ADDA is to be installed.
If installing the 9903-UDX-ADDA in a slot already equipped with a suitable
I/O module, omit this procedure.
Install a Rear I/O Module as follows:
On the frame, determine the slot in which the 9903-UDX-ADDA is to be
1.
installed.
In the mounting area corresponding to the slot location, install
2.
Rear I/O Module as shown in Figure 2-1.
2
Figure 2-1 Rear I/O Module Installation
9903-UDX-ADDA PRODUCT MANUAL
Align and engage mounting tab on Rear
1
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
Installing a Rear I/O Module
2-3

Advertisement

Table of Contents
loading

Table of Contents