Installing A Rear I/O Module - Cobalt Digital Inc 9933-EMDE-75 Product Manual

Installation and Setup

Installing a Rear I/O Module

9933EMDE-75-110-OM (V1.4)
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the card is to be installed.
If installing the card in a slot already equipped with a suitable I/O module,
omit this procedure.
Install a Rear I/O Module as follows:
On the frame, determine the slot in which the card is to be installed.
1.
In the mounting area corresponding to the slot location, install
2.
Rear I/O Module as shown in Figure 2-1.
2
Figure 2-1 Rear I/O Module Installation
9933-EMDE16-75/110 PRODUCT MANUAL
Align and engage mounting tab on Rear
1
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
Installing a Rear I/O Module
2-3