Cobalt Digital Inc 9903-UDX-ADDA Product Manual page 78

3
Table 3-2 9903-UDX-ADDA Function Menu List — continued
• Card IP Receive/Insertion Setup/Status
• Card IP Transmit/Extraction Setup/Status
3-46
9903-UDX-ADDA Function Menu List and Descriptions
IP Port Setup sub-tab provides IP setup for card UDP IP
communications.
Shows card receiving IP address/status and sets port as follows:
• Card Active IP: Shows the card IP address. (IP address is set
using Admin tab Networking settings; see Admin (Log Status/
Firmware Update - Card IP Address) on page 3-56).
• Protocol: Sets card for type of IP interface being received (TCP,
UDP, or Multicast). For Multicast, other parameter fields are
present.
• Card Port: Sets card IP receive port.
• Heartbeat Packets: Sets card to send heartbeat packets on
insertion and/or extraction links, or disable all heartbeat packet
send.
• Insertion / Rx Status: Shows card IP receive/Rx insertion status.
- Stopped (with yellow indicator) means no data is being received.
- Green indicator means data is being received and inserted. Data
rate is also shown.
Provides setup for destination IP address and shows card transmit status
as follows:
• Extraction / Tx Status: Shows card extraction from stream to Tx
status.
- Stopped (with yellow indicator) means no data is being sent.
- Green indicator means data is being extracted and sent. Data rate
is also shown.
• Destination IP/Port: Allows setting destination IP address and
port.
• Extraction Mode: Sets the IP data sent to consist of only payload,
or send as formatted packets.
• Extraction Source: Sets the IP data sent to extract from SMPTE
291M ancillary data or user Data Over Audio.
9903-UDX-ADDA PRODUCT MANUAL 9903UDXADDA-OM (V1.5)