Table of Contents
Advertisement
Rear Module Installation (Optional)
If you are installing the card into a slot with no rear module, the rear module must first be installed
before you can connect cables.
Use the following steps to install the rear module in frame:
This completes the procedure for installing the rear module in an openGear
9821 Owner's Manual • • • • (V 1.10)
1.
Refer to the openGear
installed according to instructions.
2.
On the rear of the frame, locate the card frame slot.
3.
As shown in Figure 2, seat the bottom of the rear module in the seating slot at the
base of the frame's back plane.
Figure 2. Rear Module Installation
4.
Align the top hole of the rear module with the screw hole on the top edge of the
frame back plane.
5.
Using a Phillips driver and the supplied screw, fasten the rear module panel to the
frame back plane. Do not over tighten.
®
frame Owner's Manual, to ensure that the frame is properly
®
frame.
Page 11
Advertisement
Table of Contents
