Installing A Rear I/O Module - Cobalt Digital Inc 9902-UDX Product Manual

Installation and Setup

Installing a Rear I/O Module

9902UDX-OM (V1.3)
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9902-UDX is to be installed.
If installing the 9902-UDX in a slot already equipped with a suitable I/O mod-
ule, omit this procedure.
Install a Rear I/O Module as follows:
On the frame, determine the slot in which the 9902-UDX is to be
1.
installed.
In the mounting area corresponding to the slot location, install
2.
Rear I/O Module as shown in Figure 2-1.
Align and engage mounting tab on Rear
1
I/O Module with the module seating slot
on rear of frame chassis.
DSCN3483A.JPG
DSCN3487A.JPG
Figure 2-1 Rear I/O Module Installation
9902-UDX PRODUCT MANUAL
Hold top of Rear I/O Module flush against
2 frame chassis and start the captive screw.
Lightly tighten captive screw.
Installing a Rear I/O Module
2-3