Installing A Rear I/O Module - Cobalt Digital Inc 9433-EMDE-75 Product Manual

Installation and Setup

Installing a Rear I/O Module

9433EMDE-75-110-OM (V1.6)
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be
discovered by DashBoard™ and be ready for use.
Note: • This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the card is to be installed. If installing the card in a
slot already equipped with a suitable I/O module, omit this procedure.
• Before installing card or rear module, if not already fitted make certain
rear module is fitted with fiber blindmate adapter and all protective fiber port
plugs have been removed. See Fiber and Balanced Audio Connections (p.
2-5) for instructions.
Install a Rear I/O Module as follows:
On the frame, determine the slot in which the card is to be installed.
1.
In the mounting area corresponding to the slot location, install
2.
Rear I/O Module as shown in Figure 2-1.
2
Figure 2-1 Rear I/O Module Installation
9433-EMDE-75/110 PRODUCT MANUAL
Align and engage mounting tab on Rear
1
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
Installing a Rear I/O Module
2-3