Cobalt Digital Inc 9903-UDX-ADDA Product Manual page 91

Operating Instructions
4-Character Alphanumeric Display
Item
Alphanumeric Shows card statuses (BOOT (card booting), (9903 (card up and OK))
Display
COM LED Blue LED flashes when 9903-UDX-ADDA is receiving control message from remote network control (e.g.,
DashBoard™ or Cobalt
REF LED Blue LED illuminates indicating 9903-UDX-ADDA is receiving selected reference when set up for framesync
operation.
ERR LED This function is currently reserved.
Input Active Blue LEDs for each SDI input (A thru D) indicate signal presence for each corresponding card SDI input. No
LEDs illumination of any of the LEDs indicates the 9903-UDX-ADDA has not locked onto a valid signal on any
input.
9903UDXADDA-OM (V1.5)
9903-UDX-ADDA Card Edge Status/Error Indicators and
Display
Figure 3-7 shows and describes the 9903-UDX-ADDA card edge status
indicators and display. These indicators and the display show status and error
conditions relating to the card itself and remote (network) communications
(where applicable). Because these indicators are part of the card itself and
require no external interface, the indicators are particularly useful in the event
of communications problems with external devices such as network remote
control devices.
9903-UDX-ADDA
®
Remote Control Panel)
Figure 3-7 9903-UDX-ADDA Card Edge Status Indicators and Display
9903-UDX-ADDA PRODUCT MANUAL
Input Active
Status/Error
Indicators
Indicators
Function
Troubleshooting
3-59