Installing A Rear I/O Module - Cobalt Digital Inc 9902-DC-4K Product Manual

Installation

Installing a Rear I/O Module

9902DC4K-OM (V1.5)
Note: This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9902-DC-4K is to be installed.
If installing the 9902-DC-4K in a slot already equipped with a suitable I/O
module, omit this procedure.
Install a Rear I/O Module as follows:
On the frame, determine the slot in which the 9902-DC-4K is to be
1.
installed.
In the mounting area corresponding to the slot location, install
2.
Rear I/O Module as shown in Figure 2-1.
2
Figure 2-1 Rear I/O Module Installation
9902-DC-4K PRODUCT MANUAL
Align and engage mounting tab on Rear
1
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
Installing a Rear I/O Module
2-3