Table of Contents
Advertisement
If you are installing the card into a slot with no rear module, you should have ordered and
received one rear module. You will need to install it in your frame before you can connect
cables.
Use the following steps to install a rear module in a frame:
1. On the rear of the frame, locate the card frame slot.
2.
As shown in Figure 2, seat the bottom of the rear module in the seating slot at
the base of the frame's back plane.
3. Align the top hole of the rear module with the screw hole on the top edge of
the frame back plane.
4. Using a Phillips driver and the supplied screw, fasten the rear module to the
frame back plane. Do not over tighten.
Rear Module
Figure 2. Rear Module Installation
11
Advertisement
Table of Contents
