Table of Contents
Advertisement
Overview
Installing the 9903-UDX-ADDA Into a Frame Slot
9903UDXADDA-OM (V1.5)
Installation and Setup
Chapter 2
This chapter contains the following information:
Installing the 9903-UDX-ADDA Into a Frame Slot (p. 2-1)
•
Installing a Rear I/O Module (p. 2-3)
•
Setting Up 9903-UDX-ADDA Network Remote Control (p. 2-7)
•
CAUTION
Heat and power distribution requirements within a frame may dictate specific
slot placement of cards. Cards with many heat-producing components should
be arranged to avoid areas of excess heat build-up, particularly in frames
using only convection cooling. The 9903-UDX-ADDA has a moderate power
dissipation (<13 W). As such, avoiding placing the card adjacent to other
cards with similar dissipation values if possible.
CAUTION
Note:
If installing the 9903-UDX-ADDA in a slot with no rear I/O module, a Rear
I/O Module is required before cabling can be connected. Refer to Installing a
Rear I/O Module (p. 2-3) for rear I/O module installation procedure.
CAUTION
If required, make certain Rear I/O Module(s) is installed before installing the
9903-UDX-ADDA into the frame slot. Damage to card and/or Rear I/O Module
can occur if module installation is attempted with card already installed in
slot.
9903-UDX-ADDA PRODUCT MANUAL
This device contains semiconductor devices which are
susceptible to serious damage from Electrostatic
Discharge (ESD). ESD damage may not be immediately
apparent and can affect the long-term reliability of the
device.
Avoid handling circuit boards in high static environments
such as carpeted areas, and when wearing synthetic fiber
clothing. Always use proper ESD handling precautions
and equipment when working on circuit boards and
related equipment.
Chapter 2
2-1
Advertisement
Table of Contents
Troubleshooting
