Output Video Mode Controls - Cobalt Digital Inc 9903-UDX-ADDA Product Manual

3
Table 3-2 9903-UDX-ADDA Function Menu List — continued
• Input Video Status

Output Video Mode Controls

Note:
Output Routing sub-tab is currently reserved and locked to Program Video for all SDI outputs and therefore is not
shown here.
• Analog Video Output Type Control
3-12
9903-UDX-ADDA Function Menu List and Descriptions
(continued)
Displays input status of each video input, along with elapsed time of
signal acquire.
SDI A and SDI B and Analog show raster/format for all card
inputs. If signal is not present or is invalid, Unlocked is displayed.
(These status indications are also propagated to the Card Info
pane.)
Note: Status display shows maximum card input complement.
Input complement is determined by rear I/O module used.
Provides analog video output parameter controls and
test pattern output controls for card CVBS and
component output.
Analog Output Mode sets the card analog video output from choices
shown.
Note: PAL-M choices provide a PAL-M analog output derived from NTSC
analog or North American SDI video inputs (i.e., 59.94 rate).
PAL-M is basically an NTSC signal which uses a PAL color
sub-carrier scheme. PAL-M output can only be derived from a
5994 (or related) signal. PAL SDI or analog inputs cannot be
"cross-converted" to PAL-M.
Component Color Levels sets the card component analog video output
from choices shown.
Oversampling enables or disables video DAC oversampling.
Oversampling can improve rendering of motion for down-conversions to
the CVBS SD analog output.
Color enables or disables chroma content in the CVBS output.
Test Pattern enables manual insertion (replacement) of CVBS output
video to instead output 75% color bars.
9903-UDX-ADDA PRODUCT MANUAL 9903UDXADDA-OM (V1.5)