Table of Contents
Advertisement
Rear Module Installation
If you are installing the card into a slot with no rear module, you should have ordered and received one
of the RM-9262-B module. You will need to install it in your frame before you can connect cables.
Use the following steps to install a rear module in a 20-slot frame:
All modules are installed using the same method above.
1.
Refer to the frame Owner's Manual, to ensure that the frame is properly installed
according to instructions.
2.
On the rear of the frame, locate the card frame slot.
3.
As shown in Figure 2, seat the bottom of the rear module in the seating slot at the
base of the frame's back plane.
4.
Align the top hole of the RM-9262-B with the screw hole on the top edge of the
frame back plane.
5.
Using a Phillips driver and the supplied screw, fasten the rear module to the frame
back plane. Do not over tighten.
The following section contains a drawing of the RM-9262-B module.
Figure 2. Rear Module Installation
9
Advertisement
Table of Contents
