CyberData 011214 Operation Manual page 61

2.4.9.1 Point-to-Point Configuration
When the device is set to not register with a SIP server (see
device to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The device can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note
Operations Guide
Receiving point-to-point SiP calls may not work with all phones.
Figure 2-25. SIP Page Set to Point-to-Point Mode
Device is set to NOT register with a SIP server
931562B
Installing the SIP Outdoor Intercom with Keypad
Figure 2-25), it is possible to set the
CyberData Corporation
54
Intercom Setup