CyberData 011214 Operation Manual page 43

Web Page Item
Enable DTMF Push to Talk
Prevent Call Termination
Disable HTTPS (NOT recommended)
Operations Guide
Table 2-8. Device Configuration Parameters (continued)
Description
This option is for noisy environments. When enabled, in an active call, the
remote phone can force receive only audio (setting the mic gain to max and
muting the speaker) by pressing the * key.
Pressing the # key will force send only audio (setting the max speaker
volume and muting the mic). Pressing the 0 key will restore full duplex
operation with the normal microphone and speaker volume.
When this option is enabled, a call cannot be terminated using the call
button.
Disables the encrypted connection to the webpage. We do not recommend
disabling HTTPS for security reasons.
Click on the Test Audio button to do an audio test. When the Test Audio
button is pressed, you will hear a voice message for testing the device audio
quality and volume.
Click on the Test Microphone button to do a microphone test. When the
Test Microphone button is pressed, the following occurs:
1. The device will immediately start recording 3 seconds of audio.
2. The device will play back the recorded audio.
Click on the Test Relay button to do a relay test.
Click the Save button to save your configuration settings.
Click on the Reboot button to reboot the system.
Click on the Toggle Help button to see a short description of some of the
web page items. First click on the Toggle Help button, and you will see a
question mark (
mouse pointer to hover over a question mark to see a short description of a
specific web page item.
931562B
Installing the SIP Outdoor Intercom with Keypad
) appear next to some of the web page items. Move the
Intercom Setup
CyberData Corporation
36